Customer reviews (0)Super fun two-person projectSkulptøren - 2. nov. 2025 It’s a two-person project :o) because it’s hard to stay “focused” while preparing the first casting, especially during the maximum 45 seconds (!) the casting mixture allows for stirring. It’s great fun, and the results are quite good compared to the original.
Machine translation from sinful.dk
Blimey!He looked far more realistic than expected.
Machine translation from sinful.de
Works WellEasy to use and the instructions are clear. The material was easily enough for an above average-sized member and the mould turned out very detailed. The rubber material feels of good quality and the included vibe - although it seems cheap - vibrates strongly.
Machine translation from sinful.fi
ComplicatedSir-tryalot - 17. nov. 2024 The moulding compound required to create the form of "me" must be mixed thoroughly to avoid becoming lumpy; otherwise, considerable additional work is needed, which is rather impossible given the limited time before it hardens too much to be usable.
Machine translation from sinful.dk
ExperimentSuper fun equipment that can easily be used as part of a training programme forspillet????
Machine translation from sinful.dk
SkojThis is a fun product. What others have written is true that it can be difficult to make. It took 3 attempts before I managed to get a mould. Then the silicone was not enough for one moulding. I have under length that says two cans. But has a little extra circumference which of course made it not enough. But once moulded, it is a very nice and appreciated toy for my partner, so with all that said, go for it! Now you can be three in bed so to speak. ;)
Machine translation from sinful.se
Fun stuffIt's really fun, but it's not easy to maintain a hard-on because you have to get the exact temperature of the water and then mix it with a powder to make a batter while trying not to lose your hard-on. A tip is also to buy extra silicone if you have a dick that is slightly above average in size.
Machine translation from sinful.se
Works, but can be a challenge.Recommend cutting and taping the pipe thoroughly beforehand so that it fits perfectly. Also recommend having an... excited assistant. Once the process is underway, everything needs to be ready, so to speak. It might be a good idea to buy a refill at the same time, just in case.
Machine translation from sinful.no
Really goodI don't know if the product itself is good because the instructions were so bad that I had to scrap the project. To cast the mould, you should mix the powder kit with 414 ml (4.1 dl) of water, then it should be enough to fill the tube in its full length you might think... But even though I cut the tube to the right length, there was about a whole decimeter from the mouth of the tube down to the casting mass.It was obvious that it would never be enough so to everyone reading this I would advise to completely disregard the measurement that is in the instructions and instead measure the water with the pre-cut pipe to be sure that it is not too little. I will probably give it another try in the future because after all, I want it to be my cock that fucks my wife when I'm at work. Good luck to you.
Machine translation from sinful.se
Worked great!The product worked exactly as it was supposed to. I have to admit that I was very surprised at how much detail it actually managed to include. It was almost a little scary, haha. The only downside I could find was that even though I poured the silicone in incredibly slowly and did my best to avoid bubbles, there were still a lot of small bubbles. Doesn't do much to the appearance, so I didn't really see it before I inspired, but can be annoying after you've used it because sometimes those bubbles get filled, and because they are so small, you have to take it out of each hole individually even if you wash the zen well after each time
Machine translation from sinful.no
