Clone-A-Willy DIY Homemade Dildo Kit Jet Black

Thankfully, this kit comes with a second bag of moulding powder in case you make a mistake. If it’s your first time using it, like me, you’ll probably slip up. But with an extra mould bag, just pay attention to what went wrong. Timing is absolutely crucial, as is the water temperature. Pay close attention to both. If you’re well-endowed, I’d definitely recommend getting this kit over the regular one, as the clone without testicles doesn’t include enough silicone to complete the job properly.

She adores it

I’m fortunate. But I’m also under 9 inches. I didn’t take thickness into account and lost 2” from my mould. I would have bought the thicker vibrator, but the site says one would want the larger vibrator for 9” and above. Disappointed not to get the full mould of my bits down below. Perhaps I’ll try again another time and get some extra silicone mix.

I’ll be honest, I wasn’t as happy with it as I’d hoped. I think the cylinder needs to be bigger, because when my penis was erect it was pointing more upwards, and the cylinder couldn’t tilt that high with the ball cup, so it was difficult trying not to spill it while also keeping my erection and making sure the mould was covering it properly. My penis would touch the top of the cylinder. I also put the 7-inch vibrator in for my girlfriend, and some parts were showing after the mould settled. I think you should make a more powerful three-speed vibrator that fits most penis sizes and girths, which can be inserted inside. The tiny one it comes with doesn’t compare to the pleasure of the 7-inch XL version.

Todd was able to assist me with my request, and the shop is very grateful. We will continue to stock your products.

The quality and detail that the Clone-a-Willy offers are amazing, and it’s a really easy process to complete. My only issues are that it says you can use it to make candles and ice lollies, but the mould doesn’t last very long after the first use to make anything else or multiple ice lollies. We do really like them and will probably buy more to make more.

My wife and I have done the kit twice, and it was so much fun that we bought some for our friends!

My husband and I had a lot of fun making it, but I highly recommend doing it over newspapers or on a tiled floor, as it can be quite messy. We waited a full day between making the cast and filling it with the silicone because the cast was very wet and we didn’t want to have air bubbles in the final product. Placing the vibrator was the hardest part because it was difficult to tell where it was sitting inside the silicone, but it ended up working perfectly! I don’t understand why so many people said this was difficult. We had no problems at all and had to do very little “research” before we were confident we could do it. I used my shaker bottle for the mould powder and it was mixed well in plenty of time to get it into the tube and position my husband in it. The whole process was easy and entertaining and we were laughing the entire time. Just read the instructions a couple of times before you start!

It was brilliant

Such great fun!