Clone-A-Willy Moulding Powder Refill

Like so many others, we also had a lot of problems the first time. We sat down and talked about how our approach could be changed, to make it easier for ourselves. The manual states that you must cut the tube / plastic so that it is a little longer than the penis, after which you must lose the cut area so that it is not pointed or can scratch the skin. FORGET IT! Cut the bottom off and drop that piece. We made it so that he lay down and took the tube directly over the penis so I just had to pour the moulding mass down into. We used a little more than 4 dl. (Between 4-4.5 dl MAX) The water was about 33 degrees hot. We had put EVERYTHING ready. A bowl where the powder was already in, and then a whisk, so when he got well running, I just had to quickly add the water to the bowl, stir and then pour the mass into the tube. It is so sad that many do not know this way. It's 100% the easiest way to do it - and get it in the house for the first time!

Easy to try as a second try. But, to use 425 ml of water at 32 degrees stirred for 45 sec, then I thought it takes too long to solidify. Then consider one more attempt.

Obvious if you did not succeed with the casting in the first place, although you clearly need 0.5 and not 0.315L water - As always good service.

Sure it gave me a second chance and also a third ... But did not succeed so wasted money unfortunately.

Since it can be quite tricky to get in shape on the first try, it is very good that refills are offered for a small cost. Worked just as it should, but recommend using around 400 ml of water and not 315 ml as it says in the description.

must be tried

A fun product that is highly recommended - especially if there are two of you on the job ;)

Really nice and good refill

The result is quite faithful to reality. I recommend adding a little more water than indicated.

Be quick, because this hardens very quickly!